A summary of the contents of the internet header follows:
| Bits 0-2: | Precedence. |
| Bit 3: | 0 = Normal Delay, 1 = Low Delay. |
| Bit 4: | 0 = Normal Throughput, 1 = High Throughput. |
| Bit 5: | 0 = Normal Relibility, 1 = High Relibility. |
| Bit 6-7: | Reserved for Future Use. |
| Precedence | |||
|---|---|---|---|
| 111 - | Network Control | 011 - | Flash |
| 110 - | Internetwork Control | 010 - | Immediate |
| 101 - | CRITIC/ECP | 001 - | Priority |
| 100 - | Flash Override | 000 - | Routine |
The use of the Delay, Throughput, and Reliability indications may increase the cost (in some sense) of the service. In many networks better performance for one of these parameters is coupled with worse performance on another. Except for very unusual cases at most two of these three indications should be set.
The type of service is used to specify the treatment of the datagram during its transmission through the internet system. Example mappings of the internet type of service to the actual service provided on networks such as AUTODIN II, ARPANET, SATNET, and PRNET is given in "Service Mappings" [8].
The Network Control precedence designation is intended to be used within a network only. The actual use and control of that designation is up to each network. The Internetwork Control designation is intended for use by gateway control originators only. If the actual use of these precedence designations is of concern to a particular network, it is the responsibility of that network to control the access to, and use of, those precedence designations.
The number 576 is selected to allow a reasonable sized data block to be transmitted in addition to the required header information. For example, this size allows a data block of 512 octets plus 64 header octets to fit in a datagram. The maximal internet header is 60 octets, and a typical internet header is 20 octets, allowing a margin for headers of higher level protocols.
| Bit 0: | reserved, must be zero |
| Bit 1: | (DF) 0 = May Fragment, 1 = Don't Fragment. |
| Bit 2: | (MF) 0 = Last Fragment, 1 = More Fragments. |
The checksum algorithm is:
This is a simple to compute checksum and experimental evidence indicates it is adequate, but it is provisional and may be replaced by a CRC procedure, depending on further experience.
In some environments the security option may be required in all datagrams.
The option field is variable in length. There may be zero or more options. There are two cases for the format of an option:
The option-length octet counts the option-type octet and the option-length octet as well as the option-data octets.
The option-type octet is viewed as having 3 fields:
The copied flag indicates that this option is copied into all fragments on fragmentation.
The option classes are:
The following internet options are defined:
| CLASS | NUMBER | LENGTH | DESCRIPTION |
|---|---|---|---|
| 0 | 0 | - | End of Option list. This option occupies only 1 octet; it has no length octet. |
| 0 | 1 | - | No Operation. This option occupies only 1 octet; it has no length octet. |
| 0 | 2 | 11 | Security. Used to carry Security, Compartmentation, User Group (TCC), and Handling Restriction Codes compatible with DOD requirements. |
| 0 | 3 | var. | Loose Source Routing. Used to route the internet datagram based on information supplied by the source. |
| 0 | 9 | var. | Strict Source Routing. Used to route the internet datagram based on information supplied by the source. |
| 0 | 7 | var. | Record Route. Used to trace the route an internet datagram takes. |
| 0 | 8 | 4 | Stream ID. Used to carry the stream identifier. |
| 2 | 4 | var. | Internet Timestamp. |
+--------+
|00000000|
+--------+
Type=0
This option indicates the end of the option list. This might
not coincide with the end of the internet header according to
the internet header length. This is used at the end of all
options, not the end of each option, and need only be used if
the end of the options would not otherwise coincide with the end
of the internet header.
May be copied, introduced, or deleted on fragmentation, or for any other reason.
+--------+
|00000001|
+--------+
Type=1
This option may be used between options, for example, to align
the beginning of a subsequent option on a 32 bit boundary.
May be copied, introduced, or deleted on fragmentation, or for any other reason.
This option provides a way for hosts to send security, compartmentation, handling restrictions, and TCC (closed user group) parameters. The format for this option is as follows:
+--------+--------+---//---+---//---+---//---+---//---+ |10000010|00001011|SSS SSS|CCC CCC|HHH HHH| TCC | +--------+--------+---//---+---//---+---//---+---//---+ Type=130 Length=11
00000000 00000000 - Unclassified 11110001 00110101 - Confidential 01111000 10011010 - EFTO 10111100 01001101 - MMMM 01011110 00100110 - PROG 10101111 00010011 - Restricted 11010111 10001000 - Secret 01101011 11000101 - Top Secret 00110101 11100010 - (Reserved for future use) 10011010 11110001 - (Reserved for future use) 01001101 01111000 - (Reserved for future use) 00100100 10111101 - (Reserved for future use) 00010011 01011110 - (Reserved for future use) 10001001 10101111 - (Reserved for future use) 11000100 11010110 - (Reserved for future use) 11100010 01101011 - (Reserved for future use)
+--------+--------+--------+---------//--------+
|10000011| length | pointer| route data |
+--------+--------+--------+---------//--------+
Type=131
The loose source and record route (LSRR) option provides a means
for the source of an internet datagram to supply routing
information to be used by the gateways in forwarding the
datagram to the destination, and to record the route
information.
The option begins with the option type code. The second octet is the option length which includes the option type code and the length octet, the pointer octet, and length-3 octets of route data. The third octet is the pointer into the route data indicating the octet which begins the next source address to be processed. The pointer is relative to this option, and the smallest legal value for the pointer is 4.
A route data is composed of a series of internet addresses. Each internet address is 32 bits or 4 octets. If the pointer is greater than the length, the source route is empty (and the recorded route full) and the routing is to be based on the destination address field. If the address in destination address field has been reached and the pointer is not greater than the length, the next address in the source route replaces the address in the destination address field, and the recorded route address replaces the source address just used, and pointer is increased by four.
The recorded route address is the internet module's own internet address as known in the environment into which this datagram is being forwarded.
This procedure of replacing the source route with the recorded route (though it is in the reverse of the order it must be in to be used as a source route) means the option (and the IP header as a whole) remains a constant length as the datagram progresses through the internet.
This option is a loose source route because the gateway or host IP is allowed to use any route of any number of other intermediate gateways to reach the next address in the route.
Must be copied on fragmentation. Appears at most once in a datagram.
+--------+--------+--------+---------//--------+
|10001001| length | pointer| route data |
+--------+--------+--------+---------//--------+
Type=137
The strict source and record route (SSRR) option provides a
means for the source of an internet datagram to supply routing
information to be used by the gateways in forwarding the
datagram to the destination, and to record the route
information.
The option begins with the option type code. The second octet is the option length which includes the option type code and the length octet, the pointer octet, and length-3 octets of route data. The third octet is the pointer into the route data indicating the octet which begins the next source address to be processed. The pointer is relative to this option, and the smallest legal value for the pointer is 4.
A route data is composed of a series of internet addresses. Each internet address is 32 bits or 4 octets. If the pointer is greater than the length, the source route is empty (and the
recorded route full) and the routing is to be based on the destination address field.
If the address in destination address field has been reached and the pointer is not greater than the length, the next address in the source route replaces the address in the destination address field, and the recorded route address replaces the source address just used, and pointer is increased by four.
The recorded route address is the internet module's own internet address as known in the environment into which this datagram is being forwarded.
This procedure of replacing the source route with the recorded route (though it is in the reverse of the order it must be in to be used as a source route) means the option (and the IP header as a whole) remains a constant length as the datagram progresses through the internet.
This option is a strict source route because the gateway or host IP must send the datagram directly to the next address in the source route through only the directly connected network indicated in the next address to reach the next gateway or host specified in the route.
Must be copied on fragmentation. Appears at most once in a datagram.
+--------+--------+--------+---------//--------+
|00000111| length | pointer| route data |
+--------+--------+--------+---------//--------+
Type=7
The record route option provides a means to record the route of
an internet datagram.
The option begins with the option type code. The second octet is the option length which includes the option type code and the length octet, the pointer octet, and length-3 octets of route data. The third octet is the pointer into the route data indicating the octet which begins the next area to store a route address. The pointer is relative to this option, and the smallest legal value for the pointer is 4.
A recorded route is composed of a series of internet addresses. Each internet address is 32 bits or 4 octets. If the pointer is greater than the length, the recorded route data area is full. The originating host must compose this option with a large enough route data area to hold all the address expected. The size of the option does not change due to adding addresses. The intitial contents of the route data area must be zero.
When an internet module routes a datagram it checks to see if the record route option is present. If it is, it inserts its own internet address as known in the environment into which this datagram is being forwarded into the recorded route begining at the octet indicated by the pointer, and increments the pointer by four.
If the route data area is already full (the pointer exceeds the length) the datagram is forwarded without inserting the address into the recorded route. If there is some room but not enough room for a full address to be inserted, the original datagram is considered to be in error and is discarded. In either case an ICMP parameter problem message may be sent to the source host [3].
Not copied on fragmentation, goes in first fragment only. Appears at most once in a datagram.
+--------+--------+--------+--------+
|10001000|00000010| Stream ID |
+--------+--------+--------+--------+
Type=136 Length=4
This option provides a way for the 16-bit SATNET stream
identifier to be carried through networks that do not support
the stream concept.
Must be copied on fragmentation. Appears at most once in a datagram.
+--------+--------+--------+--------+
|01000100| length | pointer|oflw|flg|
+--------+--------+--------+--------+
| internet address |
+--------+--------+--------+--------+
| timestamp |
+--------+--------+--------+--------+
| . |
.
.
Type = 68
The Option Length is the number of octets in the option counting
the type, length, pointer, and overflow/flag octets (maximum
length 40).
The Pointer is the number of octets from the beginning of this option to the end of timestamps plus one (i.e., it points to the octet beginning the space for next timestamp). The smallest legal value is 5. The timestamp area is full when the pointer is greater than the length.
The Overflow (oflw) [4 bits] is the number of IP modules that cannot register timestamps due to lack of space.
The Flag (flg) [4 bits] values are
1 -- each timestamp is preceded with internet address of the registering entity,
3 -- the internet address fields are prespecified. An IP module only registers its timestamp if it matches its own address with the next specified internet address.
The originating host must compose this option with a large enough timestamp data area to hold all the timestamp information expected. The size of the option does not change due to adding timestamps. The intitial contents of the timestamp data area must be zero or internet address/zero pairs.
If the timestamp data area is already full (the pointer exceeds the length) the datagram is forwarded without inserting the timestamp, but the overflow count is incremented by one.
If there is some room but not enough room for a full timestamp to be inserted, or the overflow count itself overflows, the original datagram is considered to be in error and is discarded. In either case an ICMP parameter problem message may be sent to the source host [3].
The timestamp option is not copied upon fragmentation. It is carried in the first fragment. Appears at most once in a datagram.